Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PRI Line at my HO terminated in a Cisco Box on a controller card. Will remote ISDN users (dialing with a TA) and PSTN users (analog modems) be able to dial in & get connected to my PRI at the same time.
Hi,I am accessing my PIX 515E through PDM. I am able to configure thru PDM but I am not able to see the real time graphs for any of the system viz CPU, memory, traffic et al utilization. It always says "Conecting to PIX, Please Wait & then Connection...
I need to connect two asynchornous devices on two separate routers over WAN IP link. The asynchornous devices are Remote terminal units having just TX, RX & GND. Moreover these devices doesnt support IP or X.25. I need to make an communication happen...
Thanks buddy but my problem is that I have a ISDN PRI only & I am bit consfused over the modem part. I have a 3640 with NM1CE1B. The ISDN PRI has been configured for 30 channels for incoming calls. There is a limitation on any further hardware procur...
I there any configuratuion to be done on the serial interfaces. As I would be terminating the async devices on WIC-2T cards at both ends. What configuration would be there on the interface end ?
One one end teh async device is a Remote Terminal Units (RTU) used for polling data & being used for SCADA systems. The other async device is a PC using its COM port. Both these devices uses three pins. TX, RX & GND only. The RTU is a DTE device , as...
Thanks buddy but I am at dead end as I have only two cisco routers at both end & I cant go ahead for any other hardware. The async devices needs to be connected on the serial ports (WIC-2T) cards on both routers without an IP & then travel over an IP...
