Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I have cisco 3850 switch, which was configured as wireless controler. I have 2 APs AIR-CAP2702E-R-K9. Both APs were connected to Gi 1/0/13-14. I see mac address of this APs on both cisco ports, but when i use command sh ap summary i get this o...
Hello! I have Cisco 3850 Switch, i want use it as wirelless controller with 10 lightweight access points. What type of licenses i need for it? As i know i should have at least IP Base license for Cisco device. What about licenses for Access Points, w...
Hello! I got new cisco 3850 yestarday and i should configure this device as wireless controller. I read some manuals and in each manuals was mantioned that for configuration Cisco 3850 as wireless controller i should use this command "wireless mobili...
Can i change to Release 3.6.6E? Can I encounter with some problems, when i change firmware from 16.6.3 to 3.6.6E ? Could you explain difference between firmwares 16.x.x and 3.x.x ?
It has :
Cisco IOS Software [Everest], Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9 -M), Version 16.6.1, RELEASE SOFTWARE (fc2)Compiled Sat 22-Jul-17 03:00 by mcpre
