Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please find a question and response I posted on the telephone netpro section. I now need a little help from you chaps in the infrastructure section. My situation is this - I have a 2650XL VOIP router and need to monitor the DSP interfaces. Jo sent me...
HI Netpro'sI need to figure out how many of our ports are being used daily on our ISDN PRI circuit. We have 25 channels active and my company I looking to add an additional 200 staff in the coming months. I need to determine if I have enough capactiy...
Hi How can I check how many active channels are being seen on my BRI interface.BT have configured 1 ISDN BRI circuit with 4 channels configured on it and only 2 of the channels are working.I told BT i need 2 physical circuits and they said I didn't ?...
HiI am running CME 7.1 IOS 12.4(24)T1 on a 1861 router and have the following issues I need some help with.1. I have 5 extensions numbers 8820 - 8825 with 8820 being the main number. The problem is that when you place a call from 8821, 8822 etc... th...
Hi netpro'sI need to run my configuration past you and ask the following questions:(I am running CME7 on a 1861 router with 2 built in ISDN BRI's)1 - When I connect my two BRI interfaces to the ISDN TA it stops me from sending and receiving calls. If...
Hi JohnSilly question but do I need to run it from the set up cd - or as Ciscoworks is installed is there a local path that I can run it from?ThanksRod
Hi P.After more investigation I have found the BT have configured my circuit with 1 physical port with the 4 channels - thats why I was getting the issue of the two interfaces coming up when making or receiving calls.I have unplugged the cable from i...
