Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,I am trying to install ccm6.12 on a hp dl320 g3, a supported box in the HCL, the installation allows me to setup all the necessary options like the DHCP, DNS, MTU and all , but atfer this process it ia suppose to start the installation, bu...
I 2 6506 switches, that are configured as Active/Standby. but the problem I am facing is that the running config on both FWSM are in Sync on both FWSM, the startup config on the active is the same as the running, but the startup config on the Standb...
I have 2 router 6506 series connecting to the same management node, they both have an Identical configuration, as they are redundant of each other, with Loopback interface as the trap-source interface, the way the network is physically configured, is...
!!! WARNING: The switch is not usable !!!I got this message from one of my 3550, it was working fine some months back while my LAB was up and running, in the last 6 months thae lab has been down. then just booted it up today to get the above message....
I did the write standby ealier, The syslog doesn't generate any report...the running congif is in sync, just the Startup...that is not in Sync...Thanks for your help...
