Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Since there is a boost in the number of MIMO. What is the maximum number of clients one can connect to these access points? Previously for MR52, I find that the sweet spot without compromising is around 65 devices. Any thoughts on this? Can i assume ...
Hi guys,
Just wondering if it is possible to perform posture check with Window native 802.1x service enabled ?
Is there a reason why Cisco Anyconnect NAM is preferred in this situation. What about MacOS ?
Hi Guys,I have set up a vMX on a VPC in AWS. The vMX is able to communicate with another VPC through peering. However, if i were to have a site to site VPN configured for the vMX to a physical MX. The clients behind the physical MX were not able to r...
So this is what i have gathered by far. VPC peering does not pass external routes. As such peering other VPC to the vMX is not going to help.Amazon is proposing a couple of things - Transit VPC- AWS direct connect- Cisco CSR router.I believe the abov...
Hi Octavian Szolga ,
Thanks for your reply. The reason why i would like to make use of the native supplicant as it doesn't require installation and that my company has 2 different operating system. Mac OS and window.
Since mac doesnt support anyc...
Hey PhilipDAth, That is exactly what i did. So basically in my setup of MX -> VMX -> VPC. My VMX was able to reach both MX and VPC. However, my MX wasn't able to reach the VPC. So according to Meraki support, they are able to see my ping going out. J...
