Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to introduce ipv6. Does it follow the same way of using private IPv6 address on the inside network (for users, switches/routers) and NAT'ing to Public IPv6 on the outside of firewall?
Hello I am looking to update my IOS XE 9300/9200 switches, currently running 16.12.5 - I see Amsterdam train (17.3.4a) and wanted to know if this would be good choice with respect to staiblity, performance issues, vulnerabilities etcWe are looking at...
Hi I think its possible to configure Cisco 3702 ?*(Autonomous AP) in WGP (Workgroup Bridge) mode connecting to ISP router (Non-Cisco) router? it works fine on Workgroup Bridge Universal mode but problem is I can connect only 1 device. In workgroup mo...
Hello all I have the following scenario, I use Eigrp for building A with mpls to my other offices within my company. Now I need to move to Building B and its slow planned phased move. I have MPLS ready in Building B but I need to use the same subnet ...
Hello I have a scenario where I need the same vlan between two different campus connected by dark fibre. I have pair of 4500-x or 6880-x switches Campus 1 ----------- Campus 2VSS Pair 1 ----L2------VSS Pair 2 | ...
Thank you so much Harry,"I see the vast majority of deployments going with global unicast addresses (GUA) internally. You could use private internally if you want, but I would definitely not recommend it."any reason why you would not recommend this s...
So if I use the public address on the inside network, then is there not a chance people can access this address from outside? (if the outside access list is allowed accidentally)like in ipv4, even if the outside acl is open, because we are using NAT...
