Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All. I'm running the IOS image c2600-io3-mz.122-26.bin with CBAC enabled. I'm not allowing port 80 through, but when I NMAP the IP subnet, every address shows port 80 open. Worse yet, I've been DDOSed on port 80 several times. Any ideas? Thanks.sh...
Hello. I have a 2611 with 64MB DRAM, 16MB Flash and a NM-4E module. I want to upgrade the IOS to IP with Firewall. The memory calculator is telling me that I need a minimum of 24MB of flash and I have to order an additional 8MB. As far as I can find ...
Hello. I am running a PIX 515E. I have a single subnet on the internal PIX int (192.168.0.0/24), no routers. I'm using PPTP to provide VPN access, works great. Problem: I need to allow VPN access from another company that is on the same subnet (192.1...
Hello. I have a 340 BR500E running version 8.55. I cannot telnet or HTTP to the device but I have console access. Telnet and HTTP are enable in the config. Thanks in advance for your help.shawn
Hello All. I'm having a problem with my PIX and PPTP VPN. I can authenticate and get and IP address no problem, but I can't access (ping) any devices inside my network. Here is my PIX config file. Any help would be appreciated. Thanks.access-list xxx...
Thanks again for your reply. I'm treating int e0/1 as an 'internal' int, that is it has the subnet on which my customers are on. I don't want to filter them on any outbound ports.
Thanks for your reply. In response to your questions, here is a layout of my setup: e0/0-----DSLINTERNAL SUBNET----e0/1[RTR]e1/0-----DSL e1/1-----DSL e1/2-----DSLThe int...
