Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a router configured on my lan, the source interface is gi0/0/0 and ip is obtained with via dhcp. My question is can I configure an acl without specifying the wan interface ip since the dhcp address changes every so often? Here is a sni...
Hello, I have an interesting issue with my sip provider. I received the MWI status in the debug messages, however my phones do not light up for MWI. I have a stripped down configuration attached. I have heard its related to codecs, but I have my code...
ICNISR4k#show versionCisco IOS XE Software, Version 16.12.03Cisco IOS Software [Gibraltar], ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.12.3, RELEASE SOFTWARE (fc5) I can run this command for a 8845 sip phone#show voice register pool 1...
Hi, I have a 3702i repeater configured autonomous and I am able to connect to it, but it seems that using a laptop or phone does not get out to the internet. From the repeater I can connect to the internet. If I set up the dot1 radio as a workgroup b...
I have a few interfaces on my router one of which I want to use a cellular interface as a backup. I am having trouble with the routing for my internal lan out to the cellular interface, though I am able to do a route statement 8.8.8.8 255.255.255.255...
This is the 2025 version I updated to work latest ISR and it adds security on (Cisco IOS Software [Dublin], ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 17.12.4a, RELEASE SOFTWARE (fc2))You may have to change the interface, I was using cel...
Yes, it works, I was able to add a secondary extension with the number and just label it voicemail, call it a day. Thank you Nithin Eluvathingal and Elliot Dierksen , I've been working on this for awhile! voice register dn 2number 1003allow wat...
Thank you yes four digits, my config is attached to the first posting, but here is one of my dn’s , so you want me to change the number in the dn to match the 10 digit voice register dn 1
number 1002
allow watch
name 1002
no-reg
label Office ...
