Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
in ucsd， can we save the worflow, i find we only have "close" button when we edit the workflow, is there any way to save the workflow?
in physical account list of UCSD, there is also missing "save" button, for example, if I add one nexus device, I wa...
I remember I click submit button when i change the bgp interface profile, now i log off from ACI, but when i login to ACI again, I found the "submit" button under bgp interface profile is not greyed out , so how would i know whether i saved or not?
before ACI, we can connect to our netapp storage, after aci project, we have DVS, and we can't access netapp anymore, we believe MTU needs to be adjusted, so should we increase MTU or decrease MTU and how much will be sufficient?
we have ucs-B server connected to FI and inside ACI favric, in aci, we already enable cdp, in UCS, do we need to change network control policyfor vnic to allow CDp since this is ucs b series and ucs b only support cdp?
also when i click "submit" button, it asks me to submit change with nodes affected info. later when I come back to this tanent, I click "submit" button, it also shows me the same screen for the change I need to submit, is this normal?
can I click t...
I didn't see the target lun, my lun is alreways zero, I have one FI, from flogi database, i get target mac address, then i put in the boot order under fc0, the other FI also has target, I put the other target mac as secondary in my booting order unde...
after discussion with my internal team, we are going to use Port 1/1,1/2,1/3,1/4 since only two ports are not safe, so the four port 1/1,1/2,1/3,1/4 will form a port channel, and connect to B series UCS server.
so should I again put 1 link in my chas...
