Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i was going through ipv6 address types i see that for Global unicast address is 2000::/3 (0010 0000 0000....like that so it used first three bit) so if we do like this for Link local address which is FE80::/10 (1111 1110 1000 000... like this only 9 ...
hi,i was trying to connect PC-SWITCH-ROUTEROn switch Fa0/1(where switch is connected) LED(link) is ON,while On switch Fa0/0(where cisco 2600xl router is connected) LED is not blinkingBut when i remove cisco 2600xl router and replaced with cisco 831 r...
hii had that problembut it is solved now.before i used linux but it was not working with my ACS file than i used microsoft server 2012 guest operating systemi was able to ping ACS ip with my laptop,but while in vmware i can not ping to laptop loopbac...
hi, so that means that for link local we have to use /10 mask1111 1110 1000 0000 0000 0000 0000 0000 .......it for link local address1111 1110 1100 0000 0000 0000 0000 0000 .......it is for site local address thanks for reply
hi, why not using until "1"??if you see global unicast address 2000::/3 its prefix only uses until last "1" so if we do by this way why not for link local address also?? and other question what is fe80:ffff:ffff:ffff:ffff:ffff:ffff:ffff and feff:ffff...
Switch#show interfaces fastEthernet0/2FastEthernet0/2 is down, line protocol is down Hardware is Fast Ethernet, address is 0009.43d6.0d82 (bia 0009.43d6.0d82) MTU 1500 bytes, BW 0 Kbit, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/...
