Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a quick question regarding the Stackwise configuration for 4 Catalyst 9300 switches. In terms of connecting them, which scenario would be correct:Connect switch 1 stack port 2 to switch 4 stack port 1
ORConnect switch 1 stack port 1 to swit...
Hi,After adding this command:snmp-server group TS v3 auth write v3View access 22 it show up like this:snmp-server group TS v3 auth write v3View notify *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF0F access 22 Any idea why this ((notify *tv.FFFFFFFF.FFFFFFF...
Hello,Does Cisco have tool to automatic configure the ports?What I mean does Cisco have tool, I can apply it to a switch, and if the devices plugged to port, the tool will assign the port configuration depends on the device MAC address.Thank you.
Hi,Is there is way to use pipe command with "show module" to display only the first table?Or is there is other command can display only the first table?The target switches are 7k and 6k. Thank you. switch# show module
Mod Ports Module-Type ...
Hi,I have Cisco switch 3750x running version 15.0(2)SE4 and I want to create port channel to 2 ports using this configuration below, when I moved some of these commands to the port channel didn't work. switchport trunk encapsulation dot1qswitchport t...
I've been reviewing the Cisco documents regarding stacking data cable connections, and I noticed that they outline three different ways to connect these cables. The only distinction they've provided between these methods pertains to the Upgrade Proce...
Thank you DanielP211 and Leo Laohoo for the reply.I have a question about the implications of connecting Switch 1 stack port 1 to Switch 4 stack port 2.I’ve noticed that some of our stacks are configured in this manner, and I would like to understand...
Hi Marce,Thank you for your reply, see below the output after applying the command you recommended. stack#sh run | i snmp-serversnmp-server group TS v3 auth write v3View notify *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF0F access 22snmp-server view v3Vi...
