Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We use NOMADIX for only banner implementaion. So client gets authenticated by WLC and has to click OK on the banner. Could have used WLC for this but sometimes we need to exclude few devices that are not capable of clicking OK on banner. Would be ...
HREAP Local Switch and Auth has been enabled on SSID.Indoor AP is in HREAP mode.Outdoor AP does not support HREAP mode.Client connects to indoor AP....continous PING breaks after client roams to outdoor AP. The state of the client is RUN.Disable HREA...
Because of delay in order I only have 4 antenna extensions instead of 12 so can use only two for each bridge.What is the impact in speed? Is it better to use two for 2.4 or 5Ghz? Distance, line of sight, interference is not issue.We will use A and C ...
Is it possible that users can roam between Cisco WLC and other vendor wireless gear? Meraki keeps saying it is possible.They keep saying it is a IEEE feature and everone should support but I do not understand how?
Tacacs not working for 3 new 5508 WLC's...working fine for 6 old 4400 WLC's.before 7.116 code upgrade...I remember 5508 was working on and off and now they are not.Same configs on SW, WLC and ACS. Debug on WLC gives..below message when Tacacs is atte...
The option "On MAC Filter failure" show the banner worked to not show banner....but found an issue...for the users that need banner, they are in a loop. When they click ok the banner comes back.The issue goes away if I disable MAC Filter Failure....a...
There are unknown clients joining the SSID, clicking the banner so I do not know their MAC address.I only know the MAC address for the devices that do not want to use WEBAUTH.
I do not want to deny access...some devices need extra privelege of not clicking banner after WLC authentication. In NONADIX we can give list of devices and they are home free. Example...environmental monitors, etc.
Does not work in 7.0.220 code either. Finally TAC filed a bug CSCty39231 to track this.In 7.0.220 based on testing methodolgy, roaming works..if you disable an AP and force client to roam to another AP then roaming works between HREAP and non HREAP.
