Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have two core switches connected back to back running hsrp for high availability.access layer switches are connected to both core switches via ten gig uplinks.i have created L3 vlans in core switch.vlan 1001 is native vlan and vlan 500 is managemen...
Hi, I have 2 routers in 2 locations. The are connected to each other via 2 leased lines on seperate routers. I want to bundle the interfaces. I went through cisco site on multichassis multilink PPP. But it is given only for dialer, BRi and PRI conf...
I have a catalyst 4500 switch. I have a problem.------------------ show version ------------------Cisco Internetwork Operating System Software IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I9K91S-M), Version 12.2(20)EW, EARLY DEPLOYMENT RELEASE ...
Hi,When this feature is enabled, the switch checks the status of the configured RADIUS servers whenever the switch tries to authenticate a host connected to a critical port. If a server is available, the switch can authenticate the host. However, if ...
I am integrating ACS with windows ADS for dot1x authentication. I m sucesfully able to get the requirement. But I have only one ACS. If my acs fails all my users will not be able to login into the network. Is there a way I can make the user get only ...
Rick, Your understanding of my requirement is perfectly right. I am going to try out this by this weekend and let you guys knuw about the outcome.Thanks and regardsArun
Darran, When the ACS goes down all the user gets guest vlan which i haveconfigured. But they dont get any ip address as well they limited access. Is it a way where i can make them part of a vlan from where they can only access internet.
In cisco homepage > go to Ordering > login using your cco ID > use dynamic configurator toolhere is the linkhttps://tools.cisco.com/qtc/config/jsp/configureHome.jspThis tool will help you to verify which module will fit which sup engine, power supply...
Hi Whenever hosts in one VLAN need to communicate with hosts in another VLAN, the traffic must be routed between them. This is known as inter-VLAN routing. On Catalyst switches it is accomplished by creating Layer 3 interfaces (Switch virtual interfa...
