Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Forum, Unable to set up a tunnel between identical ASA 5525-x over the internet even after much troubleshooting. Below are the debug output from both peers: Peer 1IKEv2-PROTO-5: (93): SM Trace-> SA: I_SPI=51A50CFEA2D5F5D5 R_SPI=0000000000000000 (I...
Hi DC Experts, We have 2 small scale DCs deployed in 2 geographically separate sites. Hyperconverged Vmware clusters in both sites. The full scenario is:More than 400km separates both sitesRTT is more than 15msNo live migrationsConnecting link bandwi...
Hello All, I've been on this for days now and have made a bit of progress but haven't quite gotten it yet. I'm trying to establish an LDAPS connection between an ASA5525-X and Ms AD on Server 2016 for use in authenticating Anyconnect VPN users coming...
Hello All,
We have a bit of a small server room design problem where we are tasked with connecting a Netapp FAS2650 storage to a Cisco Cat3850 (which is the distribution switch). My questions are:-
How can this be accomplished without the purchas...
Hi Everyone,
I'm new to this so... But been tasked with designing the networking architecture for a small DC/server room. Typically 6 to 10 servers, 10G Uplink Access to Distribution, 50TB of SAN storage... that scale. This is the first time I'll b...
Hi j.a.m.e.s,We decided to go another route by authenticating through Cisco ISE to active directory. But I'd still make out time to try out your suggestions and see and se how it works out.Many thanks!
Ok was mistaken there, the config is correct. But to address your points:-PSK is identical on both endsYes we do have multiple outside interfaces - this might actually be a part of the problem. One peer I have PBR to share traffic to both ISP but the...
Ok thanks a lot. But any other options one may consider? Someone mentioned L2tpvpn? Not so familiar with that but willing to learn, just need the most simple and straight forward solution. Also, stuck with ISR2911 for now, though it should be changed...
Hello once again, I've tried again as described above but still no luck. As usual if simple LDAP is configured, it works perefectly. Trouble starts when I add config for LDAPS. see output from debug ldap 255 below while using port 389 [-2147483637] S...
