Dear All,We have one Cisco2811 router with V-WIC-2MFT-E1 card and another router Cisco1841 with V-WIC-1MFT-T1 card.Is it possible to connect these two routers with these cardsWith RegardsAnand
Dear All,I have cisco 3745 router which is connected to two different Ehterner switch with two LAN ports. I want to configure Eth 1 interface of the router as a backup for Eth 0 interface so that once the Eth 0 get down the Eth 1 gets the IP of ethe ...
Dear All,For getting the AES 128,192 and 256 bit encryption in VPN in cisco 3745 router with advanced security IOS AIM for encryption will require or only IOS can support this feature.Kindly help out to me.With RegardsAnand
Dear Sir,Thanks for the reply. The PBX is Nortel make. Is only voice supported router with FXS interface is sufficient to do so or call manager or any other third device will required.Kindly revert me backWith RegardsAnand
Dear SirI have modifyed the dialer list according to you, but it is still not working.Is the other configuration is ok or not.Is is require some more configuratin,if yes then what that will be.Also send me what should be line configuration for this.I...