Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several 6500 in the same VTP domain that are used as access layer and trunk into two core 6500s with msfc.We use vlan254 as the management vlan so all access switches have sc0 configed on that vlan. My problem is that I can't assign an ip addr...
ANI seems to have trouble discovering 2 particular msfcs amongst about 20 that are being discovered properly. All pertinent configs are identical between the 20 msfcs that are OK and the 2 that are not (i.e. cdp & snmp enabled).A couple of difference...
Are there any published Best Practices that address the following requirement?: I would like to configure all routers in our network with a gateway of last resort to point to one routed network address to be used only for receiving traffic destined f...
I am currently unable to access the admin account. Been using WinNT login module for months without any issues but now it seems as though it won't fallback to local accounts including admin. I have tried the reset password utility but it says there i...
the vlan254 subnet is actually 10.x.254.0 255.255.255.0. All of the switchs sc0 interface are 10.x.254.x.This is why I believe I get this error. All other vlans interfaces are configured this way and there are no subnets left. My only alternative is ...
This seems like a lot of work since we are talking about 100's of routers and 1000's of clients. The intent is just to see what is "floating" around the network and being dropped. We already have a solid security framework in place. Thanks for your s...
That's not a bad suggestion at all because that is one of the things I've tried already. In fact I tried resetting several local accounts on the server with it off of the network but it keeps telling me there is no such user when I know there is. I b...
