Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have a pix 515e with the following configDMZ Exhange server and a web serverInternal a lot of servers and workstation. When i try to browse the network i cannot see the server in the DMZ. People cannot connect to the exchange server with webmai...
I have taccas config on a 1700, i want to come in trough the serial interface but i can not authenticate. i seems that i works only on the fastehternet. I can i config tacacs so the it also works on the serial interface?
I have upgraded my cisco 4500 with a new ios. I have set "boot system bootflash:cat4000-i9s-mz.122-20.EWA.bin" in my config.Still the switch is booting with the old ios.I have search on the intenet on sometimes i see "boot system FLASH bootflash:cat4...
A cat 4000 with ios 12.2.18 running with policy based routing must be upgraded to 12.2.20. I want to know if all the policy commando's are supported in this version. Is there some documentation? I can only find something from 4500.Thx
Well i some way it's not workingline vty 0 4 session-timeout 5 <= i have try this exec-timeout 1 0 password 7 logging synchronous transport input telnetversion 12.2.18Any other idea
thanks,But the problem is that it is a VIRTUAL interface.Virtual-Access3 is up, line protocol is up Hardware is Virtual Access interface MTU 1500 bytes, BW 56 Kbit, DLY 100000 usec, reliability 255/255, txload 224/255, rxload 71/255 I don´t kno...
