Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a question about the handling of the IP Address Pools on the ACS which can be used by dial in users. If I define an IP Address Pool and take one of these addresses and assign it permanently to a user (for dial in) in the ACS configurati...
Hello,is it possible to configure the PIX 501 in that way:Internal network (5 PCs) --- PIX ---DSL---InternetI have seen the configuration procedure in http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/config/pixclnt.htmbut it is n...
Hello. I also have these error messages and I want to ask if there is any possibility to see on which physical or vlan interface these frames arrive ? When there are lots of VLAN Interfaces it would take a lot of time to analyze with a sniffer. Are t...
Hello, could you make some more experiences with this issue? I have a similar problem with a second VPN client on my laptop. When cvpnd.exe is started the second VPN client can establish a tunnel to the remote VPN concentrator, but no traffic is sent...
Hello Matt, with your information I could solve my problem. I had a deeper look into my config and found an overlap in two network lists (I used for the L2L connections). After removing the overlap it works. Thanks for your help.
