Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
PIX 6.3(4)Have a seldom issue that I would like to resolve by way of address translation, if possible.Mail Server is inside the private LAN and a Email Spam filter system in the DMZ. All incoming SMTP traffic is directed to the filter using a static ...
I have a 7960 with a 7914 expansion module. If the phone rings for one of the extensions in the module and the user picks up the hanset, it will pick up the call. Is there a way to force the call to be picked up only if the button for that extension ...
Hello,I have a Cisco C3550 switch that I am experiencing some issues with. The issues relates to PXE boot (the pre-boot environment for tasks like imaging). This switch by default has the access ports configured to:switchport mode dynamic desirablesp...
I have set up a monitoring session on a 4507 switch. The intent for this session is to capture all internet traffic for filtering purposes. I configured the session using the following commands:monitor session 1 source int "port"monitor session 1 des...
Just curious to know how does WATS work and if it can be integrated into Cisco CallManager. I do not see why not, just can figure out how.Thanks,Carlos
"static (inside,outside) 66.213.26.21 insidemailserverip netmask 255.255.255.255 access-list outside_access_in permit tcp any host 66.213.26.21 eq smtp"To use your example... The above lines allow all inbound smtp traffic to my inside mail server. In...
The public MX record IP is different than my public NATed address, but both are in the same subnet block. Issue is when my Internal Mail Server establishes an smtp connection to an external mail server, the source address appears as the NATed address...
Yes, that was the only way that I could figure out. It is just more of an incovenience because the user has to pay attention to the module to ensure that none of the other lines are ringing. Just have to live with it.I appreciate the feedback.
I wanted to add that I hardcoded the interface to 100Full. That solved my PXE boot issue. Although, I am afraid that it will cause more problems than it will solve. Because all my devices (at least clients) are at autonegotiate.Thanks,Carlos
