after i upgrade my IOS to 123-8.i plug-in a new 11g module into the AP1210.the status shows hardware - down.software status shows - disabled.how do i enable the software status.interface Dot11Radio0 no ip address no ip route-cache speed basic-1.0 2.0...

encountered this error message when trying to upgrade thrpugh tftp.the tftp server is installed and running on my latop."%Error opening tftp://10.81.XX.XX/c1200-k9w7-tar.123-8.JA.tar (Timed out)ERROR: Failed to open archive file tftp://10.81.XX.XX/c1...

when i tried to save the configuration of one of my AP 1200 access point, i encountered this error message"Destination filename [startup-config]?Building configuration...nv_done: unable to open "flash:/config.txt.new"nv_done: unable to open "flash:/c...

Can 11g Access Point support 11b client ?i have a Access Point AIR-AP1231G-E-K9. Users with a 11g client adaptor is able to login successfully, but users with 11b client adaptor is not able to login.How should i configure that AP so that 11b client c...

How do i change the IP address of my AP 1200 access point through console mode ?i am able to plug in my console cable to see the bootup but i cannot go into config mode to make changes to my configuration.I need to change the IP address because i wan...