Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a remote office that we connect with 2 bundled T1's. We have recently had to move a department to this office (~25 users). We have VOIP setup as well. Question- I never see any problems with bandwidth, the least amount available has always b...
Upgraded 6.3 to 7.0 on 515E, purchased FO license for another PIX 515E. For some reason the Primary PIX wants active/active failover. I have not configured any contexts in the config, i assume it is on by default? This wont work with FO license, f...
Curious about others experiences with securing an exchange environment. Presently my exchange environment is scary vulnerable (inheritance is wonderful)...so i have tasked our group to look at a move to rpc-over-http and ssl connectivity outside of ...
Couple general questions.I am about 3 weeks into the tuning phase on my 4250XL sensor. We are monitoring the Email DMZ as well as the General Population network.Are there any specific sig that are not on by "default" that any of you would recommend,...
More specifically I have a DMZ segment that i would like to move our vendors connections (routers) over to- Currently the vendors (partners) routers are connected on my corp network- not my config (beofre i got here), but it is scary - i absolutely a...
Jeff, Quick question on this subject- if you have a second. I was in a similar situation recently, only my 1252's and WLC are actually members of a VLAN, and my WLAN/ Clients are a member of a different VLAN... I tried multiple combinations on the...
OK- figured it out. First even my rep didnt realize this...When i rebooted my FO pix, i noticed a boot error stating a 3DES mismatch. "Mate's License (VPN-3DES-AES Enabled) is not compatible with my license (VPN-3DES-AES Disabled) Failover wi...
Agreed- been there, but i have not configured any groups - all that was done was added a standby IP for the interfaces, attached the cisco FO cable, and enabled failover...This is why I am confused- the FW is set as single mode, I have tried to for...
