Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello experts,The enclosed capture is from an H323 gateway 2811 with 12.4.7 SW. VWIC-MFT-T1 digital E&M CAS trunk connected to a NEC 2000 PBX. There is a problem with failed calls outbound from the 2811 GW to the NEC. I suspect that the NEC Tx wink d...
I and trying to enable RTP header compression on a 7206 ATM DS3 card. I working with 80 VCI's and need to be enable it one sub-interface/ VCC at a time. I can't find a configuration example. 12.3 IOS
What SW is required to configure H323 Gateway in a 2801. Will advanced IP services allow H323 Gateway to be be configured on a 2801? Is the same true for a 2811?
Hi Giuseppe,Thank you for taking the time to help me. I used the feature navigator as you instructed but I did not come up with the same result. I could not verify that the ME6524 will support OER or OER BGP Inbound Optimization as I think it is call...
Thank you Paulo,You are an invaluable resource. I honestly know of no where else I can get such expert and timely advice. I will begin reseaching your recommendations immediately.
I apoligize for not giving more details in my question. We are using the ATT ATM/FR interwork network. If we change from aal5snap encapsulation to PPP would the network also have to be reconfigured?
Thank you, Paulo,I had just found the note in the configuration guide. But this may present a serious problem. My ATM DS3 main site circuit is oversubscribed with 50 T1 remote sites. We have an ATT ATM/FR interworking network. NEC 2400 and 2000 PBX's...
