Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a QSFP-40G-SR in port 1 that I would like to breakout to 10G. I'm working with a C9500-32C on version 16.9.5 and I am trying to do the command "hw-module breakout". However when I type the command in from the global configuration the only opti...
Good Afternoon, Is there a way within the CLI that you can configure a message to pop up on login to say when the previous log in was similar to how the GUI does so?
We're currently doing a tech refresh and replacing older switches with 2960s and we're having an issue with our switches displaying UKNOWN when doing the command "sh auth sess". Here's an example of the command output. The switch I use in this exampl...
I found the issue, the breakout command wasn't introduced until version 16.10.1 and later. https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-10/release_notes/ol-16-10-9500.html#concept_mjk_zb1_r2b__hw-16101-9500H
