Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Dear Community, I hope you are doing well!I have a very weird situation which I couldn't explain it. As you know , if you want to redistribute routes into different protocol , it has to be in routing table from the particular protocol which you...
Hello guys, I hope you are all good ! I experienced very very strange behavior which is totally against my QoS knowledge. As far as I know Queueing methods and cbwred is active when there is congestion . And policing is drop packets based on the s...
Hello Guys,I am sorry but my blind side is QoS . Since Simulation programs (Eve-Ng , GNS3) has no emulate QoS features , I can not see the real logic of the QoS by my own by capturing packets. Now , I need to implement QoS for ip voice traffic from ...
Hi Guys, I have 2 questions about Act/Stby Fw and L3 Out static routing (SVI) . Assume that my ACI fabric's default gateway is on FW. So if packet needs to leave ACI fabric , it must go to the FW.1) If Firewall pairs are connected to different swi...
Hello everyone , My question is a bit different about VPC loop prevention. We all know that , traffic from remote vpc member is can pass towards to vpc peer via peer-link but it is not allowed to exit from vpc member ports because of loop prevention....
Thank you so much for your answer.I got it now. So for the directly connected interfaces which are enabled at IGP level can be advertised even they are not in the routing table from this particular IGP process. Apparently . it is very enough to redi...
Hello Joseph, Does it mean if even there is no congestion , priority queue comes into play ? Because in the documents it is said that queue only comes into play when there is congestion . So is it wrong ? Because in my lab there was no congestion. ...
So does it means that if there is no congestion , the packets are still put into the queue because of the priority ? Because I checked "show run all " as well , but still did not see any policer behind of the scenes.
Thank you so much all for your helps . I will take your comments into consideration. Apparently , there is no accepted global campus QoS template. I will check the videos and read more papers that you mentioned .
