Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,We tryed without any success to get Cisco AVS 3110 FlashForwarding to work. We configured the default application classes for Flash forwarding, published config and restarted the appliance. No luck. ANy idea what could prevent Flash forwa...
When configuring trunking of VLANS accross a Port Channel, do we need to configure vlan pruning on both the port-Channel port and the physical ports ???E.g. do I need to apply the "switchport trunk allowed vlan add " command under each physical port ...
Hi everyone,We got 4 x2600 routers with VWIC-2MFT-T1 all connected in a loop topology as below ;R1--------R2! !! !R3---------R4The circuits between the routers are Unchannelized point to point T1. Our carrier says that since this is...
Hi everyone,Would anybody have a configuration example of a DMVPN spoke when NATING both the spoke and HUB site VPN routers endpoint via NAT static rules ?Cisco claims they support DMVPN with NAT but I couldn't find configuration example on their sit...
Hi,We upgraded our CSm to V4.2.2 and for one of the VIP, it looses connections to the 4 real servers every 4 hours ! Anybody has any idea what could cause this to happen ? If I use IOS SLB, I do not have this problem...
The servers ARP timeout on the servers is smaller then on the CSM. The servers default gateway point to the MSFC and then the CSM and servers have to route via the MSFC to get to/from the servers/CSM (via static routes on the MSFC and route commands ...
We did find that it is the CSM initiating the disconnects when the CSM arp entries time out. We were able to avoid the problem by increasing the arp timeout on the CSM....but we still do not understand why the ARP entry expiring would terminate all c...
Gilles,The Servers's default gateway point to the MSFC. To get the MSFC to route traffic back towards the CSM when the servers reply, we NAT the connections on the CSM with a NAT pool. and have a route for teh NAT pool on the MSFC to send the traffi...
