Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've installed the sup4 module and ws-4232-L3 module in 4506chassis.Error messeges comes out during boot procedure that unknown module and unsupported module at logging messeges.I wonder 4506Chassis does not support 4232-L3 module and how can i use t...
I have two routers with two ISP connections(dual router multihoming configurations).RT#1 EBGP peering between ISP#1 with connected serial interface, also another #2 is same.RT#1 and RT#2 has IBGP peering with their Ethernet interfaces.RT#1 BGP config...
I think it's all 'bout the fuction that combine the two DSL line as one serial line.you could check the other way with new device.It' might be easy way if you want to change router to NLB(*network load balancer)http://www.piolink.co.kr/english/produc...
The matter of fact is how many "BGP tables" and L3 traffic.I just change the device 2600(w/64M) to 3550(EMI), cause of those reasons.It was ok, when it's 1.544Mbps and contain ISP's AS table. but couldn't keep work with increased line speed and accep...
Would you paste running configuration for more details?we guess video traffic might be blocked somewhere(2811 or others). did you exchnage the only 2811 for new?if it's not, you can capture the traffic with some proper sniffer software like Ethereal,...
i guess outgoing traffic from your inside PC, would be probably right action with upper configuration in URL but, incoming packet to your WEB server(f.e) would choose one direction and 1 IP address from ISP#1 or #2because you'd get IP1 from ISP#1 is ...
