Hello,   We have a problem with a C9800 Wireless Controller (version 17.9.4a) and Cisco C9120 Access Points. Some clients are roaming from one AP to another, while there're not moving from their desk. For exemple, as shown in the exemple, a client in...

Hello everyone, I was wondering if there is a way to set a vlan tag for the ap management. Usually, the AP management is untagged on the switch config, but in a particular case, i have to keep a vlan untagged on the switch port. Thanks !

Hi, We have concerns about the use of an SSID dedicated to production, on which are Raspberry pi connected in 2. 4GHz.Users use Raspberry pi to connect to remote desktops, and the slightest disconnection cuts off the session, which sometimes happen...

Hi, We have concerns about the use of an SSID dedicated to production, on which are Raspberry pi connected in 2. 4GHz.Users use Raspberry pi to connect to remote desktops, and the slightest disconnection cuts off the session, which sometimes happens ...

Hi We facea problem with LAP1042N terminals, which suddenly try to register a bad controller after running normally.They are on a 2500 controller and we have installed a C9800-CL to migrate to new access points on site.The addition of new terminals i...