Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Using conventional HSRP configuration, everything works fine (1 gig0/2.10 with the ip and standby ip and encapsulation)---- 3750 g1/0/23 trunk dot1q encap (vlan10 with ip)same with 7206vxr router 2.When I use the port-channel 10 configuration (with t...
Hi all,config on the switchCSW0002-Data_Center#sh run int gig 1/0/22Building configuration...Current configuration : 189 bytes!interface GigabitEthernet1/0/22 description ****Mainlink S0040**** switchport trunk encapsulation dot1q switchport mode tru...
Hi all,3750 configs are as follows:SWITCH_Ainterface Port-channel1 switchport mode dynamic desirable no ip address!interface GigabitEthernet1/0/1 description *** Channel Link to CSW0011 Pantry OP Switch *** switchport mode dynamic desirable no ip add...
Hi all,Is there a way to reduce the switchover time of the SUPIV from 1.5 minutes? Once we pull out the active module the it takes about 1.5 minutes for the standby to go active. Our client wants the downtime to be reduced. Is there another way? ...
Hi,Let me get this straight first... this is like DSL connection right?so your topology would look like this...pc---switch---router 1721---cable modem---internet is this your setup?so you need to establish PPPoE on the router side... I hope I got thi...
Hi,Is this what you are trying to achieve?pc---vlan 40---vlan 50---pc? orpc---vlan 40---vlan 50---another sw/rtr?I believe that if you remove the nat statements on both interface vlan, you can still achieve inter-vlan routing?And at the same time rea...
Hi,I hope I understand your question and just ignore if this is not the case...You need to reflect the changes on both routers. The config-synchronization feature is only available on the HA of Supervisors, III, IV, 720 etc...So if you need to chang...
hi,I would like to add something to this query also.br f/r dlci 100 --------HO dlci 100 | |____f/r dlci(newly acquired)--DR site(new dlci)What my client wants is to know what configuration he needs to add either on the remote or HO or DR site...
Hi,Thanks for the reply, the bug shows incompatibility problems with NIC and Cisco Switch, my issue is incompatibility between 3com switch and Cisco switch trunking negotiations.Any comments would be greatly appreciated.Thanks all
