Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,I tried to perfrom Vlan port assignments within Campus manager but received the following errors:"one or more devices in the selected list doesn't support VPA operations"Is this MIB issue or device IOS incompability.This device is a 3560-48PS...
Hi,Will be perfoming an urgent IOS upgrade on a Cat 6513, from 12.1(19)E1 > 12.2.18SXD4.Is it nessassry to upgrade the catOS on Sup2 too?The current CatOS is 8.1(3).Can the kind folks here point me the right direction. whitepapers?Thax
Hello,i done various reseaches within cisco.com and came out a very simplified cmd to correctly perform L2 port-based rate limiting. However when applied into my test switch, i couldnt't see any counters/result captured for 'show polic-map interface'...
Hi,Router A has a LAN interface with 2 physical ip address(pri + secondary IP). The primary inf is connected to the same firewall segment. The secondary inf is connected to the switch management IP.After various ping to the secondary IP(192.1.1.10) f...
Found the issue already. The data has been purged. Thus there is no data from the first half month.There was a miss communication with the person at the site.The daily report that he was referring to is the report that has been generated daily.Thanks...
Since the limit 10,000 is based on the overall result set(CMIIW). I believe this is not the case. Since the last half month showed in the report has only <1,000 records.Any clue to find the root cause of this issue ?Thanks
Hi jclarke,Thanks for your quick response.May I know where can I find the information about this ?If I filter the messages that is displayed in the report ( e.g. only display certain Mnemonic ), Which data does the 10,000 limit will be applied on, th...
