Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to have serverfarm-1 point to www.example1.com and when all host in that server farm fail, then server farm-2 takes over, but redirects URL to www.example2.com?
Thanks,
E. Rivera
Hi,We are looking to move our FWSM (Pri & Sec) which are installed in a pair of 6500, to another pair of 6500's. My plan is to migrate the HSRP standby vlan's as well as the secondary backup FWSM to one of the new 6500's, then once that is complete,...
We will be adding 2 new Cisco 6500 onto the network. This 2 switches will eventually replace the 2 old ones. Procedures will be as follows:When introducing the 1st switch I will do the following:- make sure its setup as a client- make sure revision...
Hello, We are running cisco 515 version 6.3 & I believe on the other end they are running an ASA. We would like to change out DES Cipher to 3DES. Now we have multiple tunnels terminating at our Pix 515, but we will only be changing the Cipher for one...
Newbie to UC500 but experienced IP engineer: My model of UC500 has built-in BRI ports. I have purchased a VWIC2-2FXO card to use for the public switched network instead of the BRI ports. Cisco Configuration Assistant -> Configure -> Telephony -> Voic...
I will do it for both switches. Layer 3 is being performed by the 2 old 6500. Once I bring both new switches into production, I will migrate the routing onto the new 6500's (tweaking HSRP, OSPF, etc.) 1 vlan at a time. Eventually I will configure ...
I just found out since we have ISDN/BRI, we need to upgrade our license to support the FXO card. So now we looking into setting up a SIP trunk and we are using sip.discount.com to test, but having trouble with that as well.
