Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ASA 5555-X with 9.8(2) ioseigrp has been enabled. neighbour is visible but routing table appears in management-only routing table.how do i get it in the eigrp routing table?
I have an ether-channel configured between a Cisco 6500 and a juniper ex4500The juniper mtu is configured as 1514 and the Cisco end 1500. I am seing giants on the interface on the cisco end.Ive tried a packet capture on the port-channel but I dont se...
I have setup a site to site vpn and during testing I am trying to telnet to a device at the other end of the vpn tunnel on port 80 to simulate web access. The tunnel initiates but no traffic is passed and the telnet times out. Once the tunnel is set...
I have 2 pix's that are set up to connect to each other via vpn. but the pix's only setup as per belowthe SA seems to be fine but nothing created:Total : 2Embryonic : 0dst src state pending createdxxx xxxx QM_IDLE ...
i have site to site vpn with 2 pix firewalls. the connection works fine but when i try and use radius/acs for the ssh authentication instead of local i receive the messages under logging:710001: TCP access requested from x.1.61.12/4689 to inside:x.21...
this is what i have got configuredip audit name IDS_info info action alarmip audit name IDS_attack attack action resetip audit interface outside IDS_infoip audit interface outside IDS_attackip audit info action alarm resetip audit attack action alarm...
