Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!
Has anyone successfully setup Firepower Management Center with SSO (SAML with ADFS) together with Group Role Mapping? If so, do you have any good guide or other reference material? Have tried to figure it all out using cisco documentation but has...
Hello experts!The new unified health monitoring page in Firepower Management Center does not load and reverts back to the legacy health monitoring page. I'm running 7.1 at the moment but had the same issue on 7.0 and 6.7. I have 1 FPR1010 added to FM...
Hi.I'm trying to delete a device from Provision / Inventory but when I select a device -> resync device, edit device and delete device is all grayed out. Anyone seen this behavior and know what to do about it?Is there som CLI command to force remove ...
Hi.I am wondering if it is possible in IOS to assing a value to a variable (for instance $access_vlan) from within a macro?I do not want the set the value as a input value to the macro. More specific I want to assign the current access vlan number to...
Hi everyone.
I have some minor alarms in PI that I would like to ask if anyone else have stumbled upon.
When this job runs:
It results in this minor alarm in PI:
As far as I can see the reason is that PI sends a SNMP getBulkRequest asking the...
Decided to take a different approach to resolve the issue. After restoring a backup (7.1) to a clean FMC install the issue will reappear. The error must somehow be included in the backup. Decided to do this instead - which resolved the issue.A clean ...
Hi.I did some investigation using API calls and it turns out the Provision engine was causing my issue: "failureReason": "NCIM11010: Device x.x.x.x cannot be deleted as it is being used by DNA Provision application"I reprovisioned the devices and for...
Hi.I do not want to pass the value as an argument. The goal is to run the macro from ISE with just the name of the macro. I do not know the what the access vlan number is on a specific switch.If possible I would like to assign the value like this:$ac...
