Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi Friends,I have a need like this,There are systems running on our BNG router topology with an average of 15 thousand subscribers.We have difficulty monitoring these, we monitor the traffic with commands directly on the device and when there is a pr...
hello everyone,I have a problem like thisWe will move from mikrotik to cisco asr9k bng,I made all the configs to run it as pppoe bras on the bng side, butNo PADI, etc. in debug aaa, radius, ppp, pppoe logs. information is not comingI connected the mo...
hello everyone,I have a problem like thisWe will move from mikrotik to cisco asr9k bng,I made all the configs to run it as pppoe bras on the bng side, butNo PADI, etc. in debug aaa, radius, ppp, pppoe logs. information is not comingI connected the mo...
hello everyoneI have a problem guys,1 piece standalone cisco ise v2.4 I use it in the building500 to 800 users are working''now; map authentication side is actively working now ''anyconnect is installed on all computers and config is ready,and when I...
QinQ is a different matter.Double-tagged VLANs are a different matter.QinQ – you can set this up simply by connecting two switches together, without the need for ISP-level configurationUsing SVLAN.However, you should use a router that supports dual-t...
On systems with limited hardware, I have always carried out the double-tagging process using the native VLAN.After all, the whole point of double-tagging is to ‘encapsulate and modify the native VLAN’ – something many people are unaware of…because th...
If you want to run dual-tagging with a single PE,you need to set up a Native VLAN on the switch side;you will be running it as Dot1q on the PE, so you must define it as a second VLAN under a sub-interface. As I mentioned in my previous post, if you c...
Hello, my friend,You need to configure this on the QinQ CE client-side switch.All L2 switches support the QinQ port type. Let’s move on to how this is implemented on the ISP side.If you are connecting multiple points using standard L2VPN services on ...
Hi,Are the values below the same? Are there any differences, gaps, etc., on either side of the NCS?identifier type 0 70.0d.00.01.00.01.00.03.00Does the VPN perform NCS synchronisation via BGP? In other words, can you see the routes on both BGP instan...
