About Paw_Paw

Paw_Paw · 03-20-2019

Hello My Name is Cedric. I have a customer which two sites. On every site is an ISR4431. I use a DMVPN tunnel with NHRP Protocol. On both side is a line with 500Mbit/s WAN access. My problem is now, that I have not more then 200Mbit/s over the VPN ...

Paw_Paw · 02-02-2024

We have always configured HSRP for the customers. If routing protocol, then BGP. We did not configure OSPF with customer.

Paw_Paw · 02-01-2024

Good MorningWhen the routers are devices from the ISP, they do not allow you to choose the technology. Ask your provider what they prefer.The technologie choices are provided above but I assume you are not able to choose which one you want.regards

Paw_Paw · 02-01-2024

HiI play a lot with leaking and vxlan in the lab and it looks not that bad. But I do not find an example configuration on the Cisco Documentation. I would like to know if I am doing it on the right way or see what best practice is. I only found some ...

Paw_Paw · 01-31-2024

Its a very old topic, but if someone else has this problem: in my case, the opposite switchport was configured as a trunk, while I had an access-port. That can be trigger this error.

Paw_Paw · 12-15-2023

does anybody found a solution for that problem? I have the same issue in my eve-ng lab. I am not sure if this problem eve-ng related or nxos related.

Member Since	‎04-05-2018 07:16 AM
Date Last Visited	‎07-25-2024 05:42 AM
Posts	16
Total Helpful Votes Received	6

User Statistics

User Activity

DMVPN between two ISR4431 Throughput performance

Re: Active-Active Edge topology

Re: Active-Active Edge topology

Re: VXLAN route leaking between vrf

Re: Spanning Tree

Re: Nexus 9K 9.3.3 PBR Error "ACL redirect adjacency allocation f