Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI need to move some switches into the new fabric zone. To my knowledge, the only way to do this is to remove the devices from inventory and re-add them via the discovery procedure using the switch's IP address.I've tried to use the "Assign to s...
HiI'm planning to add new WiFi 7 access points (APs) to my existing WiFi 6 environment. Are there any design guidelines or considerations for mixing these two technologies, particularly regarding client connectivity? Here are some key points I would ...
Hi I have a couple of questions about Cisco SDA and Cisco Catalyst Center (DNA)I need to change some configurations on my Edge Nodes after I provisioned in the live networkDNA version: 2.3.71. change the hosname: I've found some documents that mentio...
Hi EveryoneJust had a little bit of a confusion with ASA failover and was wondering if anyone had any experience with itI have two ASA 5500-X in failover mode (Active/Standby), each connected to a different switch in vPC.I checked the Active and Stan...
Hi I have the following scenario and little confused about the technology and topology that need to be used RTR1 and RTR2 are the service provider routers (CE), and the provider informed us that they have an active-active connection via BGP.The quest...
thanks @Andrii Oliinyk @Enes Simnica @balaji.bandi I think I need to check removing the switch from the fabric process. In the meantime, I tried to rediscover it using ‘discover existing switch’, but it didn’t work because the border lost its configu...
Hey RaduThanks for the heads-up.Actually, I've decided to go with Wifi 6e at this stage instead of Wifi 7 due to issues like upgrading the WLC and to avoid mixing Wifi 7 and Wifi 6.
Another solution that comes to mind is to purchase WiFi 7 access points, such as the 9177, and only enable either the 5G or 2.4G band. This way, there won’t be any issues on the client side. We just need to ensure firmware compatibility and perform u...
Hi SaikatThanks for the feedback and clarification!1. About versioning, as you and Leo pointed out, we’ve got plans to upgrade the firmware. As long as we can manage both the old and new access points (APs) on a supported version, we should be good t...
