Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning! I am fairly new to Cisco UCS, so any help you can provide would be much appreciated. I have some B200 M5 blades here where I am trying to map the diagnostics image in order to test the blades for a customer. After successfully mapping ...
Good afternoon. Running full diagnostics on a C240 M4 server. It has two drives in slots 0 and 1, but the diagnostics ran a test for slot 4 which does not contain a drive(which it failed). Any ideas why it would run this test with no drive in the ...
Good afternoon. I have a C240 M4 server that won't power on fully. I have two UCSC-PSU2V2-1400W in the server with 200 - 240V power connected to it. The power supplies blink green for awhile and then become solid, but the power button in the front...
I do do that, but the mapped device does not appear. See pics below. This only happens with all the B200 M5 blades. If I put an M4 in the chassis, I can map the diagnostics and run it with no problem.
