Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm wondering if there is an 'easy' way of allowing a host on a DMZ access to the internet (HTTP) but without allowing it access to the internet LAN (also HTTP).To clarify the scenario, you have an ASA with 3 interfaces. Internal, DMZ, Outside. Le...
Hi all,I have notice that while on a router here at work (using telnet) over the Fa Int. If I ping anyone of the IP addresses configured on S0.{blah} (FR local sub interface) the echo reply times are around 44ms?? Shouldn't a local interface reply mu...
I have seen a similar issue.The fact that the debug shows two echo replies sent at the exact same time indicates the router is receiving to echo requests.Our situation is to do with the upstream devices which run HSRP, and one of these devices doesn'...
Hi,What commands have you configured to route between VLAN 8 and VLAN 1? You'll need to have an SVI in place somewhere on VLAN 8 with an IP Helper Address pointing at your DHCP server on VLAN 1 and your DHCP server should have a scope setup for VLAN ...
That's the minimum valid message size required by the IEEE 802.3 specification. I don't think there is any payload in a frame that small? These days with faster links I think the idea is to have larger frames not smaller frames.
