Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm deploying a new MPLS/EVPN ring using Cisco N540-24Q2C2DD-SYS routers and I'm trying to decide which IOS XR release to standardize on.Right now I'm running 25.2.21, which is the latest Service Pack release for the 25.2 train. The alternative would...
anyone know how to get a stuck card out of its funk. i've tried everything under the sun. First this is mpa 1 on: NCS-57C3-MODS-SYS. So the slot is only capable of 400Gb. For whatever reason even though it is not configured it appears to be in a...
i'm sure there is an easy way of doing this, but i'm not finding it out there. I want to push the installation files to peoples computers. Mainly our tech users first before deploying to our other users. We do use connectwise automate, but am not ...
does not ipv4 verify unicast source reachable-via rx cover doing ingress access-list on the access edge? I'm trying to figure this out, but i'm not 100% sure it does. I'm trying to figure out if i need both. I probably need to do any if i turn to ...
btw - didn't know cisco tech support watched the forums wondering why i didn't use them sooner. Being a small isp the resources are harder to find because of the uniqueness of what we have to all do. Thank you for your service!
i appreciate you looking at that. i have done the hw-module subslot 0/0/1 shutdown /no form. a lot. when i do that it just creates Hu0/0/1/0 admin-down admin-downHu0/0/1/1 admin-down admin-downinstead of what would be expected:Hu0/0/1/0 admin-down a...
i do have an open case on it. that is where i got the from admin hw-module location all reload from the tac on that deal. i just was hoping to jar it loose.
ok so here is what i have on my config for the controller very simple:controller Optics0/0/1/0cd-min -4000cd-max 4000transmit-power -100fec CFECdwdm-carrier 100MHz-grid frequency 1921500modulation 16QamDAC-Rate 1x1.50RP/0/RP1/CPU0:#sh run formal | i ...
