Hello all, I receive the below error in ISE when trying to test aaa radius authentication on Cisco switch acting as authenticator. below is the test and error snapshots
Hello,
I 'm having a problem accessing the GUI Interface of the Viptela vManage controller v20.4.1. the application server is waiting even when I restarted it.
-------------
vManage# sh int vpn 512interface vpn 512 interface eth1 af-type ipv4ip-addr...
Hello,
I'm trying to use Ansible to configure Cisco SMB SG-350 switches , but its failing to SSH, when trying to gather facts. the error message appears is:
fatal: [10.75.2.2]: FAILED! => {"changed": false, "msg": "Failed to authenticate: ('Bad authe...
Thanks for your reply.
actually, the aaa config is being pushed by Cisco DNA center to the switch, so I assume config should be fine.
I did another test and intentionally typed wrong password. I got a rejection from the ISE server:
The error me...
Hi Aleksandra .. good point.
I tried removing the MGMT ACL, but it gave me the same results.
however, I found something interesting, when I try to SSH directly to the swicth, it give a propmt to enter my username again (although I already entered it ...
Hi Aleksandra,
Thanks for your reply. in fact GUI is disabled, but SSH is enabled on the switch. also, I can SSH directly from the Ansible Server, but Ansible playbook cannot do. below is the output from direct SSH.
[root@srv1]$ ssh user1@10.69.13.2
...
Below is the playbook YML file.
I'm using ansible_network_os: qaxi.ciscosmb.ciscosmb in the host file.
- name: Gather Facts
gather_facts: no
hosts: switches
vars:
- configs_dir: configs
tasks:
###
# Collect data
###
...
