Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Resetting 7900 Series IP Phones:http://www.cisco.com/en/US/partner/products/hw/phones/ps379/products_tech_note09186a00800941bb.shtml***Please rate helpful posts!
You would need to do somethng like the following:controller T1 0/0/0pri-group timeslots 1-24trunk-group test-1 timeslots 1-17trunk-group test-2 timeslots 18-24Then use the trunk groups on the dial-peers as needed.
***Please rate helpful posts!
CME/CUE can work with either sip-notify or rtp-nte (RFC 2833). To reduce issues, it would probably be best to just pick one and run with it. If you session into the CUE module and run "sh ccn sub sip" you will see the DTMF method that CUE is using ...
Have you defined the web username and password under telephony-service on CME and that CME is configured as an http server?:conf ttelephony-serviceweb admin system name password exitip http server***Please rate helpful posts!
Provided that your CSS and PT assignment is setup in CUCM properly that should work. Typically if you have a H323 GW that is going to be acting as a SRST GW, you want to do everything on the VG that way you only have one point of failure and nothing...
