Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco community,I would like to request support from the community, I'm running in a blocking situation where I cannot finish the first setup because I'm blocked in the Setp #11, configuration of the NTP SERVER SETTINGS (Image attached).Every t...
Hello guys, One question, I want to know which country code I must choose to register my AP cisco AIR-CAP3502I-A-K9 on the WLC? The controller was set up to use the following country code:But the AP cannot register. Can someone help me with that? th...
Hi guys, I setup a simpleLAB with ESAv and SMAv. I already configure the ESAv with the following configuration: From VirtualBOX I setup 3 virtual Adapters on Vmnet1 (192.168.202.0/24), Vmnet2 (172.16.0.0/24) and Vmnet3 (172.16.1.0/24). Ex Vmnet2 con...
Hello folks,
I have a cisco ip phone 8865 at home and I want to connect it by VPN to the work telephony system which run asterisk, any idea how to do this, at home I only have a normal router, it is not a cisco router. In my work I have a VPN server...
Hi Leo,Ok, please see the output of the commands below:(Cisco Controller) >show timeTime............................................. Sat Apr 17 08:03:54 2021Timezone delta................................... 0:0Timezone location.........................
Hi Vivek, The problem is options, i change the sip.conf in asterisk, and the phone work, basically I removed all the options and add only the essential in [general] and the phone work. I think this is a good choice, because now i can add more options...
Hi Wilson,
I disabled the authentication in the sip.conf file with command:
allowguest=yes
And in the SEP.XXX.cnf.xml i remove the password too.
And than the Cisco phone apper in the Asterisk with the following error:
The SIP phone is th...
