Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Has anyone performed an upgrade on the NCS 540 from IOS-XR 7.11 to 25.2 while using a management interface configured within a VRF for Smart Licensing connectivity? After upgrading from 7.11 to 25.2, I'm encountering an issue where Smart Licens...
Hi Team,
I'm finalising a design that requires IP SLA ICMP Echo as the object tracking method for HSRP and static route failover on the following platforms:
NCS 5000 series (IOS-XR)NCS 500 series (IOS-XR)
Background:
This is a confirmed and well-docu...
Hi team,
I am trying to test NDFC 4.1.1g but bumped into a strange issue that I haven't experienced before in previous version.
This is my lab setup:
4 x n9000v, version 10.4.4M. 2 sites, each site has 2 x n9000v. Configure them as back-to-back...
Hi team,
This may be dumb but I can't find a good deployment type of guide to explain this with customer.
I have a SD-WAN and the routers are having tunnels going to CSA using the Network Tunnel Group. Use case is using SIA with SWG.
What is t...
Hi team,
This may seem dumb but I could not find a straightforward way to do this without using the CLI add-on.
Trying to create a loopback address within a particular service VPN, which is used as network management. But the feature adding interfa...
Thanks for answering.
However, I was not even there yet. I was at the step of importing switches. Right after importing switches, I was supposed to set roles and calculate the topology to push config the very first time. NDFC just reported error a...
Thank you for providing the screen shots. However, I am working on the config using the newer Configuration Group method. Under the Service VPN (which is equivalent to the Service Profile VPN template), adding Ethernet Interface and name it as loop...
This may be too late but the answer is, this feature configures the anycast gateway on the border gateway device.
Below is a sample snippet of the configuration generated:
vrf member v1no ip redirectsip address 192.168.10.254/24 tag 12345no ipv6 re...
Answering to myself again, after getting a "secret" channel to ask the Nexus Dashboard TME.
The answer is, officially not verified by QA team and therefore not recommended.
Even with vMotion, it is not officially supported.
Official approach is bu...
