Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyobdy,We are facing a problem of remote desktop connectivity from outside to one of the server among other servers in the same IP range inside of the ASA5520 running IOS version of 7.2 and Device Manager Ver.5.2.I have copied extended and s...
Hi,There is an issue of Unknown Number display on IP Telephone while calling from PBX extension (Ericsson PBX) to the IP telephone.Where as IP telephone extension number is displayed on PBX phone when calling from IP telephone.Verified necessary conf...
Hello, We have a problem on our WAN Router cisco 2800 as interface fa0/0 is getting down for every 45 secs and will come back after 4 to 6 RTO's, We have configured GRE tunnels for remote branches DMVPN, this problem is encountered after one or two o...
Hello,We have a problem on our WAN Router cisco 2800 as interface fa0/0 is getting down for every 45 secs and will come back after 4 to 6 RTO's,We have configured GRE tunnels for remote branches DMVPN, this problem is encountered after one or two of ...
Hello,We are having problem for incoming calls after integration of PBX system (Ericsson)with Cisco IP telephony integration has done successfullyBut there is an unknown number message displayed on IP phones instead of actual phone extension numbers ...
Configuring replication between two ACS will look two servers almost similar in configurations and user databases after successful replication with different IP's running in different modes such as primary and secondary ACS.Replication can be configu...
Using Network Access Restrictions (NAR) will work in this scenario. Best approach will be creating separate user groups for each department and then enable shared NAR in group properties and select appropriate department NDG's in order to restrict th...
Do verify appropriate PEAP or EAP-TLS check boxes are selected under Global Authentication Setup. In case if the Dot1x supplicant used is a Cisco Supplicant then you need to select cisco LEAP as well under Global Authentication Setup in your ACS SE.H...
Moreover Network Configuration device table can be backed up from the running ACS and can be restored on another ACS with missing NDG's under Backup and Restore.Configuration of replication between ACS's will be followed.HTHAhmed
Do verify the required replication components are selected on primary ACS such as User Database and Configurations etc.,check boxes are selected in send option and the same components are selected for receive option check box in secondary ACS.Hope th...
