Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have ACS 4 and we use a 4404 wireless lan controller. In the past month we've been experiencing outages for our wireless clients. We get alert messages from ACS like "Auth server down: Could not change Password" or "Test Timed out for service: C...
When configuring isakmp key "keyname" address x.x.x.x netmask y.y.y.y - what are the allowed characters for the shared key? I did a search and found several articles that said it could be alphanumeric. I have some existing connections that are usin...
Is there a way to get a PIX to log what vpngroup is used when creating a VPN connection? Syslog is recording PIX-4-602301 when the SA is created but it doesn't say which group was used. I could even get what I needed if I knew what IP address the P...
I have a 6509 with sup720's and a ws-x6516-gbic module. The 6516 has been powered down since I started and today I tried to power it up but received the following error message"%SYS-2-MOD_UPGRADEREQUIRED:Module 3 not at an appropriate hardware revis...
I have a 2811 router at a remote location. The router's Ethernet port has 3 subinterfaces, - the main interface is unnumbered but 0/0.1, 0/0.2 and 0/0.3 are numbered and are using dot1q encapsulation. If I do a ping command I have to do the extende...
We ended up running cable to replace all of the 3Coms. We never got a resolution and we couldn't continue spending so much time trying to get them to work.
I know what my vpngroup names are, I want them to be recorded in syslog messages.Here is an example %PIX-4-602301: sa created, (sa) sa_dest= 12.227.x.x, sa_prot= 50, sa_spi= 0x9133272c(2436048684), sa_trans= esp-3des esp-md5-hmac , sa_conn_id= 17I kn...
We ended up deleting all the access points from the 2nd server and then doing another replication. Afterwards everything started working. They believe the first replication was corrupted somewhow.
Working w/ Cisco TAC I created a new network device group on each ACS server - set a key for the NDG and moved the ACS servers to the new group. Replication was successful after that. However, after doing that our wireless clients weren't able to a...
