Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attempting to create routed port between a pair of SG500x.
Show run shows: set system queues-mode 4
GUI System Operation Mode: L3 and L2 mode
Interface has IP address assigned.
When I enter the no switchport command get incomplete command. Options ...
Attempting to create routed port between a pair of SG500x.
Show run shows: set system queues-mode 4
GUI System Operation Mode: L3 and L2 mode
Interface has IP address assigned.
When I enter the no switchport command get incomplete command. Options ...
I am stuck figuring the correct commands to create Layer 3 port-channel between the sg500x and a 3550.
On the SG500 I have:
interface Port-channel3
ip address 10.100.31.1 255.255.255.0
&
interface gigabitethernet1/1/19
channel-group 3 mode a...
Sorry, removing portfast didn't change anything. On a reset of the 3550 port, the link comes up for short period, then says suspended due to remote not enabled for LACP
Thank you Thank you Marvin. I wasn't able to revisit this ASA issue for a few days. In the meantime, the PC hosting the ASDM was rebooted and now the other FirePower tabs, buttons, and menu options are visible. Maybe a cache issue, there...don't k...
Thanks again. I upgraded the ASA to 9.5(2) and the module to 6.0.0. However, I can't see any change in asdm gui. The messages at the end of the firepower install... "Note that registering the sensor to Firepower Management center disables on-senso...
Thanks for that info. Which direction do you suggest? This will be the only ASA in the organization.
I have always enjoyed reading your posts. Thank you for your great contributions.
