Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When a flow statistics is performed in debug mode on a CSS what do the following fields actually meanFM TCP Flows Timed Out 51FM UDP Flows Timed Out 0FP TCP Flows Timed Out 430419...
Redundant SCM does not boot in a CSS11506The boot file is as follows!************************ BOOT CONFIG ************************ primary boot-file sg0810107s primary boot-type boot-via-disk passive primary boot-file sg0810107s passive primar...
I have a requirement to send traffic to another server on the private side using the VIP address. I understand source groups need to be defined for this requirement to NAT the source ip address of server. There is also a requirement to send traffic t...
This is more of a general question. I am devising a QoS model with 5 to 6 classes. I want to apply WRED to 3 of these classes and drop packets more agressivley with some of these classes to differentiate the class. Are there any guidelines which Cisc...
Does the Cisco Service Provider IOS have the capability to support L-LSP. Need to find out if we can support more then 8 CoS using the E-LSP.Is there any other mechanism for supporting more then 8 CoS on an MPLS backbone
Hi Syed Iftekhar, What does the FM TCP Flows Timed Out 51 exactly mean. Does it mean a flow is setup in the slow path and it is not pushed to the fast-path cache but still abides by the flow-timeout parameter?Pravin
Hi Giles,We simulated a failure by removing the primary SCM in slot 1 and the CSS rebooted but the standby SCM did not boot. We had to reseat the PMCIA flash disk in the standby SCM to boot it properlyPravin
My initail thoughts were to have two or three drop predences using WRED for two classes of service. So I will exceed the 8 if I have a queue for voice and separate for video with another for Best Effort
