Hi All,I am trying to setup PPPOE on ISR4321 (first time) to connect to the ISP (replacing an old no cisco router). It looks like the link comes up but weirdly the router (Dialer interface) receives two IP addresses and it doesn't install a default r...
Hi All,I am a bit puzzled with the behavior of point-to-Multipoint non-broadcast. I have ospf configured over WAN ( WAN is MPLS L2 managed by the provider).What I expected with point-to-Multipoint non-broadcast, you have to have the command neighbor ...
Hi All
we are the process of changing the service provider for our WAN (5 sites + HQ). Currently its point to point with HQ and we are using static routes ( as we know not very scalable)...
The new WAN will be mesh ( MPLS Layer 2) so all the route...
Hi AllI have the following situation where I don't really know which solution to pick , would really appreciate some help : The network diagram is attached (Cores switches are 4506): My question is what is the best solution for users connected throu...
Hi All,I tested earlier and the connection come up like last time ( I added ip mtu 1492 and removed the ppp ipcp route default). when I try to ping from the router iteself no connectivity then the decided to connect a laptop directly to the internal ...
Thank you for the explanation. I have tried ip route 0.0.0.0 0.0.0.0 dialer1 but without removing the ppp ipcp route default. I'll give this a try today and update here.
