This is exactly where I am stuck now as well. Luckily we found out early that we had to change the mode from bridge to local so we can download the image that will support this AP. Currently our WLC 5508 is running a 18.104.22.168 image which was recommended by Cisco TAC to support "mesh" design. Unfortunately since the upgrade I am unable to change the mode from local to bridge so I can join the AP's as MAP.
Last comment recommended going to 8.5 to be able to change the mode. I need to know if I need to upgrade my WLC to 8.5 or 8.4 code to make the mesh work with these AP's 1562e.
FYI I have 2 other 1552 ap's working as a mesh configuration. Thanks for any replies.
... View more
Apologize in advance if this is not the right forum I posting this in as this is a my first post.
I have an ASA5515. Current primary ISP (outside) is a static IP. We are in process of installing a backup using a wireless modem that gives out IP using DHCP. When I try to set a secondary static route for ATTbackup it asks for Gateway which I don't have because it uses a different gateway. My question is how I can set this up. Here is my current configuration so far:
interface GigabitEthernet0/1 nameif outside security-level 0
dhcp client route track 1 ip address 75.X.X.X 255.255.255.248 ! interface GigabitEthernet0/2 nameif ATTbackup security-level 0 dhcp client route distance 10 ip address dhcp setroute
route outside 0.0.0.0 0.0.0.0 75.X.X.X 1 track 1
track 1 rtr 1 reachability
sla monitor 1 type echo protocol ipIcmpEcho 22.214.171.124 interface outside sla monitor schedule 1 life forever start-time now
... View more