CUCM Translation pattern allows to prepend digits to the dialed number. To add a suffix , the only option is to use translation rule on the gateway.The following translation rule appends a 0 to the end of the dialed number. voice translation-rule ...
Partitioning is based on number of "logical" disks.With Raid Type 1(1+0) two logical drives are created on each pair of hard drives. CUCM 6.0 Disk Partition Size 1 disk - Active and Inactive partitions get 18.25%, boot/swap get a chunk (2.2MB) an...
A pause cannot be inserted using the Translation pattern in CUCM.The alternative is to do the manipulation on the gateway. With MGCP there is no way you can insert a pause. However, with H.323, you can use the comma character in the prefix in Dia...
The CUCM by default provides different ring cadence on the IP phone for on net and off net calls but its not possible to configure different ring tones. The ring cadence doubles in frequency for off net calls. The 'Chirp 1' chirps twice when the ...
For Call recording you will need to integrate CUCM with an external Call recorder .The Recorder must interface with Cisco Unified Communications Manager SIP trunk to receive recording calls.Nice/Witness Recorders have been tested; Verint and other...
Hi Rachel, The Recording profile DN should match the route pattern, the route pattern in turn points to the SIP trunk towards Media sense. When the device has an active call, based on the dn's recording profile configuration,cucm will dial out to me...
Hi Mark, Go to CUCM enterprise parameters and look for 'URL Directories' under 'phone url paramaters'.The default url is 'http://<CUCM Hostname>:8080/ccmcip/xmldirectory.jsp' If the default url has not been altered,you could try changing the 'CUCM h...
Hi Fabien,
Have you checked the rtcp timer setting on the gateway.
Please take a look at the below survivability configuration snippet from the config guide.
For a Unified CVP Comprehensive call flow model, define the following services:
applicatio...
Hi Aniket, This is a vast topic. However to get started, you read through the design guide and configuration guide for CVP.Design Guide:http://www.cisco.com/c/en/us/support/customer-collaboration/unified-customer-voice-portal/products-implementation-...
Hi Chinedu, I believe you are talking about CUCM publisher. Typically in the publisher is dedicated for admin activities and it is the subscriber who handles the call processing. From what you mentioned, I understand you have a callmanager group with...