Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I see CUCM voice ports as the calling DN in RTMT trace logs. I am trying to understand how a CUCM voicemail port can be the calling DN of an outbound external call? I don't see any Call handlers that are transferring calls to external numbers...
Hi Community, I have a fax line connected to an FXS voice gateway port. The caller ID from the ports to external number only shows the 4 digit number of the CUCM route pattern, not the full 10-digit DID. My provider will be blocking any calls that...
Hi Community, I received notice from my Service Provider that certain DNs are sending only the DN (e.g. 1234) and not a valid 10 Digit number in the SIP invite. They indicated further that "The general CLID rule is the CLID field must be a dial abl...
In our environment we have Cisco IOS Enhanced Conference Bridges configured in CUCM. We use a 2911 router for our voice gateway which has 2 x PVDM3 DSP DIMM with 32 Channels installed. In CUCM Service Parameters > Conference Clusterwide Parameters w...
Hi
I have a few hundred c7945 phones registered. The majority show the load/active IDs as follows:
Load ID - SCCP45.9-4-2SR1-1S
Active Load ID - SCCP45.9-4-2SR1-1S
I’ve noticed about 10 show the Active Load ID to be different:
Load ID - SCCP45.9-...
Thanks for your response.. The calls are very seldom. I have only seen 1 or 2 in the last month that are destined to an external local number. I am no expert but I'm just not sure in what scenario would allow a voicemail port to make an external ca...
Thanks Rajan for your reply but I edited my original port to clarify my issue. I am seeing CUCM voicemail port extensions making external calls in RTMT call traces (as the calling DN). There are no Unity call handlers with input options to transfer...
Hi Prassha,Thanks for your reply. I managed to find some documentation on the topic below: https://www.cisco.com/c/en/us/support/docs/voice/analog-signaling-e-m-did-fxs-fxo/23444-callerid-name-del.html I made a change to the voice-port config on the...
If you uncheck Use Calling Party's External Phone Number Mask, then you can configure the Calling Party Transform Mask. Enter a number such as 978858xxxx (CallManager fills out the xxxx with the phone's 4-digit extension). If you don't have a device ...
